Siemens SINAMICS SH150 - Page 9

C Quality documents....................................................................................................................................125
D Additional documents ...............................................................................................................................127
Index.........................................................................................................................................................129
Tables
Table 3-1 Deionized water requirements.....................................................................................................31
Table 3-2 DRIVE-CLiQ interface .................................................................................................................40
Table 6-1 Cable cross-sections...................................................................................................................70
Table 6-2 Cleaning agents and grease .......................................................................................................74
Table 8-1 LEDs of the Power Stack Adapters ............................................................................................85
Table 8-2 LEDs of the Sirius safety relay ...................................................................................................86
Table 9-1 General checklist for preventive maintenance work....................................................................91
Table 9-2 Control Module: Checklist for preventive maintenance work ......................................................92
Table 9-3 Tightening torque for screws.....................................................................................................100
Table 9-4 Tightening torques for screw terminals for copper cables without cable lug 1).........................100
Table B-1 Standards and regulations ........................................................................................................121
Table B-2 Climatic environmental conditions.............................................................................................122
Table B-3 Mechanical ambient conditions .................................................................................................122
Table B-4 Other ambient conditions ..........................................................................................................123
Figures
Figure 2-1 ESD information ..........................................................................................................................18
Figure 3-1 Drive design ................................................................................................................................27
Figure 3-2 Block diagram: Basic Line Module with diodes ...........................................................................28
Figure 3-3 Block diagram: Active Line Module employing M2C technology.................................................29
Figure 3-4 Interface overview of Power Stack Adapter 5 .............................................................................33
Figure 3-5 Power cell....................................................................................................................................34
Figure 3-6 Operator panel ...........................................................................................................................37
Figure 3-7 Line filter......................................................................................................................................38
Figure 3-8 Auxiliary supply and signal interfaces .........................................................................................40
Figure 4-1 Example of attaching and displaying the shock and tilt indicators ..............................................44
Figure 4-2 Example illustration of centers of gravity.....................................................................................46
Figure 4-3 Lifting bar label............................................................................................................................48
Figure 4-4 Securing the lifting rods...............................................................................................................48
Figure 4-5 Transporting a transportation unit (still in packaging) with a crane .............................................50
Figure 4-6 Example: Label with instructions for opening the doors..............................................................52
Figure 5-1 Screwing the cabinets together...................................................................................................59
Table of contents
SINAMICS SH150 6SL3805
Operating Instructions 05/2020 9