808D ADVANCED Page 15 Programming and Operating — Turning
Tool Setup
s
SEQUENCE
Create
tool edge
Step 1
Press the “Offset” key on the PPU.
A tool must have been created and
selected with the cursor before creating
a tool edge.
Press the “Edges” SK on the PPU.
Use “D” code to represent the tool edge. The system activates the
No.1 tool edge as default at the beginning.
Use direction keys to select the tool which
needs to have an additional a tool edge.
or
Press the “New edge” SK on the PPU.
Press the “Tool list” SK on the PPU.
→
→
→
→
Example
Common tool edge position code choices are as follows:
To Next Page
Loading...
