Siemens SINUMERIK 808D ADVANCED Training Manual

808D ADVANCED Page 69 Programming and Operating — Turning
Additional
Information
Part 1
s
SEQUENCE
Use the “Copy” “Paste” SKs to transfer the part program from
NC to USB.
Press the “USB” SK on the PPU.
Press the “NC” SK on the PPU.
Press the “Copy” SK on the PPU.
Press the “Paste” SK on the PPU.
Step 5
Use the “Copy” and “Paste” SKs to transfer the part program
from USB to NC.
Press the “NC” SK on the PPU.
Press the “USB” SK on the PPU.
Press the “Copy” SK on the PPU.
Press the “Paste” SK on the PPU.
Connect a USB device with sufficient memory to the USB interface on the
PPU.
Connect the USB device with the stored target programs to the USB inter-
face on the PPU.
“USB” is used to transfer the programs to and from the NC.
Step 4
Use “Cursor + Select” to select the required part
program. The selected program will be highlighted
+
Use “Cursor + Select” to select the required part program. The
selected program will be highlighted
+

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English