808D ADVANCED Page 67 Programming and Operating — Turning
Additional
Information
Part 1
s
Content
SEQUENCE
Unit Description
This unit describes how to perform simple tasks on the machine and
provides some additional information which may be required to operate the
machine correctly.
Unit Content
RS232c
+
USB
Help
R
parameters
Time
change
Save data
Gear
change
RS232c
+
USB
RS232c is used to transfer the programs
to and from the NC.
Step 1
Adjust the parameter settings on the PPU to match the settings of the
communication SW on PC.
Press “Program Manager” on the PPU.
Press the “RS232” SK on the PPU.
Press the “Settings” SK on the PPU.
Adjust the parameters in “Communication settings” to match the settings of
communication SW on PC.
Press the “Save” SK on the PPU.
Press the “Back” SK on the PPU.
It is recommended to use the “Sinucom PCIN” communication SW
provided by Siemens to transfer the standard program.
End
Shared
Network
Drive
To Next Page
Loading...
