PLC Programming Tool
2.7 PLC application Download/Upload/Copy/Compare
PLC Subroutines Manual
Operating Instructions, 12/2012, 6FC5397-2EP10-0BA0
25
Upload
You can backup a PLC application from the permanent memory of the control system using
the PLC Programming Tool or an USB stick.
To upload a PLC application using the PLC Programming Tool, proceed as follows:
1. Create a new and empty PLC application using the PLC Programming Tool:
2. Establish the communication between the CNC controller and the PLC Programming Tool
with an RS232 cable.
For information about how to establish a communication between the CNC controller and
the PLC Programming Tool, refer to section "Establishing a connection with the RS232
interface (Pa
ge 17)".
To Next Page
Loading...
