4. Select the "example-V2.2.0.wic" image file.
5. Click "Start".
Note
Preparing the SD card
Erase all existing partitions on the SD card before you start.
dd
Parameter Description
if Input file
of Output disk/partition
bs Blocked space (10 MB is recommended)
--progress Shows the progress
Procedure
1. Use "dd" to install the image.
Download "dd" at the following link:
dd (http://www.chrysocome.net/dd)
- OR -
From the zip. file:
dd zip (http://www.chrysocome.net/downloads/dd-0.6beta3.zip)
Note
Erase all partitions
To avoid malfunctions, erase all existing partitions on the SD card before you start.
2. Run, e.g. the following command:
Note: Run the following lines as a command:
dd if=D:\temp\example-V2.2.0.wic of=\\?\Device
\Harddisk1\Partition0 bs=10M --progress
Windows computer
1. Open Windows "CMD" as administrator.
2. Open the directory in which "dd.exe" is stored.
Installation/configuration
4.5 SIMATIC IoT2040
Manage MyMachines /Remote - installation in existing control environments
Application examples, 10/2018, A5E45211403B AB 37
To Next Page
Loading...
