8.3 SINUMERIK controller is ONBOARDED
In this chapter you will be shown were to see if a Machine is "ONBOARDED" in the Sinumerik
Integrate 5.
You have to make the same steps with all applications:
● Manage MyResources /Programms
● Manage MyResources /Tools
● Optimize MyProgramming /NX-Cam Editor
Procedure
1. Again open the "Plant management" window.
2. The machine is displayed with the connection status "ONBOARDED" in the overview.
Connecting applications with the SINUMERIK control system
8.3 SINUMERIK controller is ONBOARDED
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
178 Installation Manual, 12/2019, A5E44672080B AE
To Next Page
Loading...
