Installation
9229 0025 176 0E 41
2021-11-15
Removing and mounting metal cover
Removing • Loosen both upper M6 hexagonal bolts but do not unscrew them.
• Unscrew the bottom four M6 hexagonal bolts with the contact washers.
• Lift the cover (20.2) slightly upwards and remove.
Installation • Position the openings of the cover (20.2) over the upper hexagonal bolts and
the contact washers and hook in the cover.
• Put contact washers on the hexagonal bolts with the gearing facing the cover
(20.2) and screw M6 hexagonal bolts in with a tightening torque of 12 Nm.
Fig. 49 Removing metal cover – example Fig. 50 Mounting metal cover – example
To Next Page
Loading...
