Installation
42 9229 0025 176 0E
2021-11-15
Mounting the cable outlet for the external cable harness (optional)
A cable outlet (60) with fixing material is included in the supplementary equipment
for the external cable harness mounted by the customer. The cable outlet serves to
bundle and protect the cables coming from the low-voltage interface.
Self-tapping screws are suitable for single use only.
• Remove cover (see “Removing and mounting cov-
ers”, page 40).
• If present, pull off the plastic cover (61) toward the
front.
• Mount the cable outlet (60) with the cable harness so
that the cable harness is routed to the back of the
pole shells.
• Fit the cable outlet with the self-tapping screws (Torx
screwdriver, size 20) and a tightening torque of
3Nm.
• Attach the plastic cover (61) from the front and push
it up to the cable outlet.
• Mount cover (see “Removing and mounting covers”,
page 40).
Fig. 51 Example – mounting the cable outlet
To Next Page
Loading...
