Siemens SIRIUS 3RW5 - Page 53

Mounting and dismantling
4.4 Removing the 3RW5 communication module from a level surface
SIRIUS 3RW5 Modbus communication module
Equipment Manual, 03/2020, A5E43676481002A/RS-AC/003
53
4.4 Removing the 3RW5 communication module from a level surface
Requirements
● 3RW50 soft starter
● Removed bus connector (Page 63) or removed bus connection cable (Page 67)
● Removed COM connecting cable (Page 59)
● Screwdriver (depending on the drive of the screws)
Procedure
Illustration similar
1. Loosen the head screws on the 3RW5 communication module.
2. Pull out the push-in lugs from the 3RW5 communication module.
Result
You have removed the 3RW5 communication module and can now mount another
3RW5 communication module.