Siemens SIRIUS 3RW5 - Page 60

Connecting
5.1 COM connecting cable
SIRIUS 3RW5 Modbus communication module
60 Equipment Manual, 03/2020, A5E43676481002A/RS-AC/003
5.1.4 Remove the COM connecting cable on the 3RW50 soft starter
Requirements
● 3RW50 soft starter
● Removed hinged cover
Further information on removing the hinged cover can be found in the Equipment Manual
of the 3RW50 soft starter.
● COM connecting cable removed from the 3RW5 communication module (Page 59)
Procedure
Illustration similar
1. Loosen die securing mechanism on the bus connector of the COM connecting cable.
2. Pull the bus connector of the COM connecting cable out of the socket on the
3RW50 soft starter.
3. Install the hinged cover.
Further information on installing the hinged cover can be found in the Equipment Manual
of the 3RW50 soft starter.
Result
You have disconnected the COM connecting cable from the 3RW50 soft starter.