Index
© Siemens AG, 2004. All rights reserved
I-62 EMC Installation Guideline – Planning Guide (EMV) – 03.2004 Edition
I
Inductors...................................... 2-14, 7-45
Inspection window ................................ 5-29
Insulated component structure ............. 4-24
Interference sink .......................... 3-16, 8-49
Interference sizes ........................ 3-15, 3-16
Interference source .............................. 8-49
Interference source wiring .................... 2-14
Interference suppression...................... 7-45
Interruption point................................... 6-41
L
Light bulbs ............................................ 2-14
Lighting ................................................. 2-14
Lightning protection .............................. 6-35
Lightning strikes.................................... 2-14
Line dividing points ............................... 6-35
Line length ............................................ 6-36
Line shield ............................................ 6-38
M
Magnetic fields...................................... 2-13
Mains filter ............................................ 5-32
Mains supply lines ................................ 6-40
Mass ..................................................... 2-13
Material................................................. 5-29
Meshing ................................................ 4-20
Minimum distance ................................ 2-13
Monitors................................................ 5-31
Motor lines ............................................ 2-14
Motor supply lines ................................ 6-40
N
Nominal lines ............................... 2-14, 6-35
O
Operating devices ................................ 5-30
Overvoltage .......................................... 2-14
P
Packaging............................................. 9-52
Plug housing......................................... 6-41
Potential compensation bus ................. 2-13
Potential compensation lines ................ 2-13
Potential-free signal transmission......... 4-19
Power components ............................... 5-31
Power current lines ............................... 2-13
Power lines ..................................6-35, 6-40
Power supply lines ................................ 2-13
Protection earthing................................ 7-47
Protective line systems ......................... 4-19
R
RC wirings............................................. 7-45
Reference potential............................... 2-14
S
Screw connections.......................2-13, 5-29
Shield bus ...........................2-13, 5-32, 6-37
Shield contact .......................................2-14
Shield effect .......................................... 5-30
Shielding ......................................5-33, 6-37
Shielding braid .............................5-30, 6-38
Signal lines...................................2-13, 6-35
Single-sided shield connection ............. 6-39
Spare lines ............................................ 6-35
Support bar ........................................... 5-31
T
Terminals .............................................. 6-41
Typical interference sources................. 3-16
U
Unfiltered lines ...................................... 2-13
Unshielded lines.................................... 6-35
V
Ventiducts ............................................. 5-29
Ventilation openings.............................. 5-30
Ventilation slots..................................... 5-30
W
Wiring....................................................7-45
To Next Page
Loading...
Need help?
General