Siemens SISTORE AX4 - Page 36

Configuration
36
Siemens Building Technologies SISTORE AX4_EN.doc
Fire & Security Products 09.2004
3.7.4 Pre-Event Recording Setup Screen
Fig. 47 Pre-Event Record Setup screen.
When the DVR is in the Event Record mode, it is possible to have it record images
before the event occurs. The Pre-Event Record screen allows you to define how to
handle pre-event recording.
You can turn individual cameras On or Off for pre-event recording. The image
speed can be set from 0.5 to 30 ips (25 ips PAL), and image quality can be
selectable from High, Standard and Low.
NOTE:
The pre-event recording speed is 30 images per second (25 ips for PAL) when the resolution is set to
Standard. However, when set to High, the recording speed will be decreased to 15 images per
second (12.5 ips for PAL).
You can set the amount of time to record prior to the event by adjusting the Dwell
Time. You can set the Dwell Time from 1 to 300 seconds.
NOTE:
When the DVR is in the Time-Lapse mode, it ignores the pre-event settings and follows the time-lapse
settings.