SITRANS P DS III (7MF4.33.. 7MF4.34.. 7MF4.35..)
6 A5E03434626-03, 06/2013
Nameplate with approval information
On the opposite side is the nameplate with approval information. This nameplate shows e.g. the hardware and firmware
versions. You must also observe the information in the relevant certificate for a transmitter version for use in hazardous
areas.
Characteristics for hazardous area
Maximum surface temperature (temperature class)
Category for operating area
Figure 1-2 Example of a nameplate
Transportation and storage
To guarantee sufficient protection during transport and storage, observe the following:
● Keep the original packaging for subsequent transportation.
● Devices/replacement parts should be returned in their original packaging.
● If the original packaging is no longer available, ensure that all shipments are properly packaged to provide sufficient
protection during transport. Siemens cannot assume liability for any costs associated with transportation damages.
Insufficient protection during storage
The packaging only provides limited protection against moisture and infiltration.
Provide additional packaging as necessary.
Special conditions for storage and transportation of the device are listed in "Technical data" (Page 35).
The contents of this manual shall not become part of or modify any prior or existing agreement, commitment or legal
relationship. The sales contract contains all obligations on the part of Siemens as well as the complete and solely applicable
warranty conditions. Any statements regarding device versions described in the manual do not create new warranties or
modify the existing warranty.
The content reflects the technical status at the time of publishing. Siemens reserves the right to make technical changes in
the course of further development.
To Next Page
Loading...
Need help?
General
