en Getting to know your appliance
12
Time setting
Time setting
When the appliance is switched on the
for the first time, the time starts at 12:00
o’clock.
Set the time as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press Info button { 8 for 3
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4. Keep pressing button > )R until the
time setting is indicated on the
display window at the top @.
5. Make the setting with setting buttons
+ - X. If the selection buttons + -
X are held down, the set values
are changed in 10-minute steps.
6. Press and hold the Info button {
8 for 3 seconds.
The chosen setting has now been
stored.
Note: If the appliance was
disconnected from the power supply for
a prolonged period, the time starts at
12:00 o’clock. Set the time.
Initial start-up
When the dishwasher is switched on for
the first time, you are taken directly to
the settings for the initial start-up.
Note: If you select Home Connect
during the initial start-up, make further
settings via your dishwasher App.
Observe the supplied Home Connect
documents.
On the display window at the top @
the following text appears for manual
selection:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
The required settings for the initial
start-up are listed in the table below.
To change the setting:
1. Keep pressing button >)R until the
required setting is displayed.
Change the setting with setting
buttons + -X.
2. Press and hold the Info button {
8 for 3 seconds.
The chosen setting has now been
stored.
Initial start-up settings Factory setting Infotext
by pressing Info button {
Sprache/Language Deutsch Language selection.
Home Connect Manual/Home Connect Manual/Home Connect.
Time format 24 h 12h or 24h.
Time setting 12:00 Set the current time.
Water hardness °E 16 - 20 medium Adjustment to the local water hardness.
When using Multitabs, select setting 0 - 6.
* depending on the features of your dishwasher