en Water softening system/special salt
18
+ Water softening
system / special salt
Water softening system/special salt
To ensure good rinsing results, the
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l) must
be softened. The water is softened with
special salt (regeneration salt) in the
water softening system
of the dishwasher. The setting and
therefore the required amount of salt
depends on the degree of hardness of
your tap water (see following water
hardness table).
Water hardness table
Adjusting the water softening
system
The amount of salt dispensed can be
set from 0 to 62°E. Salt is not required
at the set value 0-8.
Set the softening system as follows:
1. Ask your local water utility company
for the water hardness value of the
tap water.
2. Required setting can be found in the
water hardness table.
3. Open the door.
4. Switch on ON/OFF switch (.
5. Press Info button { 8 for 3
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
6. Keep pressing button > )R until the
water hardness is indicated on the
display window at the top @.
7. Make the setting with setting buttons
+ - X.
8. Press and hold the Info button {
8 for 3 seconds.
The chosen setting has now been
stored.
:DWHU
KDUGQHVV
YDOXH(
VRIW
PHGLXP
KDUG
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
PPROO
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
6HWYDOXH
RQWKH
PDFKLQH
+DUGQHVV
UDQJH
KDUG
KDUG
PHGLXP
PHGLXP
VRIW
To Next Page
Loading...
Need help?
General
