Getting to know your appliance en
13
--------
Settings
The dishwasher has been preset with
certain settings for your convenience.
However you can also change this
factory setting.
To change the setting:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press Info button {8 for 3
seconds until the following text is
indicated on the display window at
the top @
Scroll with < >
Set with - +
Leave with Setup 3 sec.
.
4. Keep pressing button >)R until the
required setting is displayed.
Make the setting with setting buttons
+ - X.
5. Press and hold the Info button {
8 for 3 seconds.
The chosen setting has now been
stored.
You have the option of resetting all
changed settings back to the original
factory settings.
Note: When you reset your dishwasher
to the factory settings, you are taken
directly to the settings for the initial
start-up.
Rinse aid disp. Level 5 Amount of rinse aid affects drying. When
using Multitabs, select setting 0.
Water connection * Cold water Connection to hot water (40-60°C) or cold
water (<40°C) possible.
Initial start-up settings Factory setting Infotext
by pressing Info button {
* depending on the features of your dishwasher
Basic setting Factory setting Infotext
by pressing Info button {
Time setting 12:00 Set the current time.
Time format 24 h 12h or 24h.
Time display Time Show end of programme with display
"Finish in" or "Finish at".
Sprache/Language German Language selection.
Water hardness °E 16 - 20 medium Setting water hardness. When using
Multitabs, select the lowest setting.
Rinse aid disp. Setting 5 Amount of rinse aid affects drying. When
using Multitabs, select setting 0.
Sensor setting Standard Adjustment of soiling detection for
optimum cleaning result.
* depending on the features of your dishwasher
To Next Page
Loading...
Need help?
General
