Troubleshooting
Disturbance Cause
and troubleshooting
Leftover food on dishes
dishes.
Washing program selected that
is too weak.
▶ Choose
a stronger washing program.
→
"Programs", page 19
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
▶ Only
remove large food residues and do not pre-
wash the dishes.
Tall, narrow vessels are not rinsed sufficiently in the
corner area.
▶ Do not
store tall, narrow vessels at an angle or in
corners.
The
upper dish rack on the right and left is not set at
the same height.
▶ Adjust
the upper dish rack to the same height on
the left and right.
→
"Upper dish rack", page 23
Removable streaks
are located on glasses,
glasses with a metallic
appearance
and cutlery.
The amount of rinse aid added is set too high.
▶ Set
the rinse aid system to a lower level.
→
""Setting the amount of rinse aid added", page 29
No rinse aid is filled.
▶ Add rinse
aid.
→
"Filling with rinse aid", page 28
Detergent residues are present in the rinse program section.
The lid of the detergent compartment was blocked by pieces
of crockery and did not open completely.
1.
Place dishes in the upper dish rack so that the tab
drip tray is not blocked by dishes.
→
""Putting away the dishes", page 33
The dishes are blocking the cleaner lid.
2.
Do not place dishes or air fresheners in the tab drip
tray.
Dishes have
been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
▶ Only
remove large food residues and do not pre-
wash the dishes.
50
To Next Page
Loading...
Need help?
General
