Siemens TQ505DF8 - Basic Operation; General Information; Switching the Appliance on or off

en Basic operation
54
Level German de-
grees in
°dH
Total hard-
ness in
mmol/l
1 1-7 0.18 - 1.25
2 8-14 1.42 - 2.49
3 15-21 2.67 - 3.74
4
1
22-30 3.92 - 5.34
1
Factory setting (may vary according to
model)
5. Press ⁠.
6. Check whether the bean container
has been filled.
7. Check whether the water tank has
been filled.
8. Press ⁠.
a The appliance rinses itself.
Tip:You can change the water hard-
ness at any time.
→"Overview of the basic settings",
Page61
General information
Please bear this information in mind
so that you can get the best out of
your appliance.
Notes
¡ The appliance has been pro-
grammed at the factory with stand-
ard settings for optimum operation.
¡ The grinder has been factory-set
for optimum operation. If coffee is
only dispensed drop by drop or is
too thin and with too little crema,
you can adjust the grinding level
when the grinder is running.
→"Adjusting the grinding level",
Page59
¡ The appliance will switch off auto-
matically if it has not been oper-
ated for a given period of time.
You can change the duration in the
basic settings. →Page61
¡ Water droplets may form on the
ventilation slits and the lid of the
ground coffee compartment while
the appliance is in use.
¡ For technical reasons steam can
escape from the appliance.
Tips
¡ You can switch off the button
tones in the basic settings.
→Page61
¡ When you use your appliance for
the first time or run a service pro-
gramme, or if your appliance has
not been used for a long time, the
first drink will not have its full
aroma and should not be con-
sumed.
¡ Once you have started up your ap-
pliance and made a few cups, you
will then achieve a thick, fine-pored
crema every time.
Basic operation
Basic operation
You can find out everything you need
to know about operating your appli-
ance here.
Switching the appliance on or
off
▶
Switch the appliance on or off with
⁠.