Siemens Uroskop ACCESS - Endoscopy Monitor (TFT)

8 Urodynamic interface
UROSKOP ACCESS SPL5-330.814.01.05.02 Siemens AG
08.05 CS PS 24
Page 8 of 18
Medical Solutions
Installation 0
• Remove the rear panel, the cover, and the right side panel (as viewed from the front of
the container) from the imaging system container (see also the document "Installation
Instructions; System" [SPL5-330.812.01]).
• Install the scan converter (3/Fig.1/p.8) und den OTV (4/Fig.1/p.8) (optical isolation
amplifier) in the imaging system container of the UROSKOP Access.
- No OTV is installed if an endoscopic interface is present.
Fig. 1: Imaging system container
Pos. 1 Image signal splitter 2 (reference image)
Pos. 2 Image signal splitter (live image)
Pos. 3 Scan converter
Pos. 4 Optical isolation amplifier (OTV)
Pos. 5 Scan converter holder