EasyManua.ls Logo

Siemens VersiCharge - Installation and Maintenance Schedule

Siemens VersiCharge
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix
A.3 Installation and maintenance schedule
VersiCharge AC Wallbox IEC
Operating Instructions, 03/2021, A5E50366109-AA
67
A.3 Installation and maintenance schedule
Introduction
Depending on the area of application, perform the general cleaning work and maintenance
work every 6 months. Shorten this interval according in the event of difficult usage
conditions.
Follow the regionally valid regulations on servicing and maintaining this type of electrical
charging equipment.
Cleaning
Remove dirt/dust/residue from the device and the usage area. Wipe the surfaces with a damp
cloth. For stubborn stains, use a cleaning agent containing alcohol. Do not clean the device
with a pressure washer. Do not use aggressive cleaning agents.
Check
Check the device for the following:
Cuts, damage and soiling
Defects and rust
Clearly visible signs of faded colors
Residue or damage on the cables, cable holders and plugs
Signs of rust on the plug pins
Accumulation of snow around the VersiCharge
Contact the supplier if you notice any anomalies.
Avoid accumulation of snow around the VersiCharge. Clear the area accordingly. In heavy
snowfall, clear the area daily.

Table of Contents