NLSet up and connect
▶ Transport the device upright.
4.4 Remove transport
protection devices
Place of installation
Holder
Requirements
The device with
locking tabs
→
Page 29
to confirm.
The device is secured for transport
with transport locks on the back of the
device.
Remark:Keep the bolts of the
transport protection devices and the
sleeves for later transport.
→
"Install transport protection", page
49
Floor with wooden
beams
Place the device
count on a
resistant
wooden plate (thick
too minimal
30mm) which
screwed firmly
to the floor.
1.Pull the hoses out of the holders.
Kitchenette The device al-
borrow under one
continuous work
place sheet,
that with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
2.Loosen and remove all bolts of the 4
transport protection devices with
an open-end wrench SW13
.
Remark:If
the cover plate
will be removed,
must be the metal
cover plate
→
"Accessories",
Page 29
in front of
building it in
be confirmed
tid.
On a wall No mains connection
cable and none
snakes in between
wall and equipment
wedge in.
14
To Next Page
Loading...
