NLService
4.Slide the detergent drawer into the
appliance.
13.10 Soak laundry
Remark:No additional detergent is
required. The soapy water is then used
for washing.
13.8 Starting the program
1.Start the program.
Required:A program is set.
→
"Set program", page 30
2.To pause the program, press after
approx. 10 minutesStart/ Refill.
▶ onStart/Refillto press.
3.To resume the program after the
desired soaking time, press Start/
Refill.
aThe drum spins and finds one
load recognition takes place, which
can take up to 2 minutes, after
which the water flows into the
device.
aThe display shows the program
duration or the program end time.
aAfter program end it shows
display:End.
13.11 Adding laundry
After the program has started, you
can remove or add the laundry
depending on the program status.
1.onStart/Refillto press.
13.9 Change activated
program end time
The device pauses.
Remark:If you want to add laundry,
follow the instructions on the
display.
→
"Display", page 23
You can change the set and changed
program end time several times
before you start the programme.
2.Open the door.
3.Add or remove the laundry.
4.Close the door.
5.onStart/Refillto press.
Requirements
¡The program is set.
→
"Set program", page 30
¡The program end time is set
and activated.
→
"Buttons", page 24
13.12 Progr. Cancel
1.onStart/Refillto press.
2.Open the door.
1.onStart/Refillto press.
The activated program end time is
paused.
At high temperature and high
water level, the door of the
appliance remains locked for safety
reasons.
– At a high temperature, start the
programmeTo rinse.
– Start the program at a high water
levelCentrifuge or select a
suitable program for draining.
→
"Programs", page 25
2.onReady in press to it
display the desired program end
time is shown.
3.onStart/Refillto press.
The changed program end time is
activated.
32
To Next Page
Loading...
