Siemens WU14UT20NL - Before First Use; Laundry

NL usage
g6
use
Before first use
5.Fill powder detergent into
compartment II.
gB
use
prepare the appliance for use
use.
6.1 Start wash cycle without
laundry
Your appliance has been thoroughly
checked before leaving the factory. To
remove any residual water, wash
without any laundry for the first time.
1.The program selector onClean drum
to make.
To avoid foaming, use only half the
amount recommended by the
detergent manufacturer for light
soiling. Do not use wool or delicate
detergent.
2.Close the door.
3.Pull out the detergent drawer.
4.Approx. Pour 1 liter of tap water into
compartment II.
6.Slide the detergent drawer into the
appliance.
7.To start the program, press Start/
Refillto press.
aThe display shows the remaining
program duration.
aAfter program end it shows
display:End.
8.Start the first wash cycle or turn on
the program selectorOut to make,
to turn off the device.
→ "Essentials of the Operation",
Page 30
20