NLSet up and connect
2.Connect the water inlet hose to the
tap (26.4 mm = 3/4").
plastic stand
pipe with rubber
run muff or one
floor drain
The water
feeding hose with
a bend
→
Page 29
fix and bor-
gene.
4.6 Adjusting the device
To reduce noise and vibrations and
avoid the device walking, set the
device horizontally.
1.Loosen the lock nuts with a SW17
open-end wrench.
3.Carefully open the tap and check
that the connections are tight.
Water outlet connection types
The information will help you connect this
appliance to the water outlet.
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can become detached
from the installed connection position.
▶ Secure the water drain hose against
unintentional loosening.
Remark:Observe the pumping
heights.
The maximum pumping height bed
The connection position
tie with one
hose clamp
(24-40 mm) Bore
gene.
Washbasin The water
feeding hose with
a bend
Page 29
honor and
n.
→
fix
ge
16
To Next Page
Loading...
