Set up and connectNL
2.To adjust the device, turn the device
feet. Check the horizontal
adjustment of the device with a
spirit level.
1.Insert the mains plug of the
appliance's connecting cable into
a socket in the vicinity of the
appliance.
The connection data for the device
can be found in the technical data
ā
Page 52
.
2.Check the mains plug for tightness.
All device feet must be firmly on the
floor.
3.Tighten the counter nuts against
the housing hand-tight with a
SW17 open-end wrench.
Hold the appliance foot firmly
and do not adjust the height.
4.7 Connecting the device
electrically
Remark:Your domestic electrical
installation for this appliance must
comply with local legal and safety
regulations and
eagle contains-must be earth leakage
ten.
17
To Next Page
Loading...
