NLCleaning and maintenance
1.Since there may still be residual
water in the pump, carefully
unscrew the cover.
4.Fit the pump cover.
‒ Check that the pump cover
components are fitted correctly.
‒ Large impurities can cause the
filter element to become stuck in
the pump housing. Loosen
impurities and remove filter
element.
5.Tighten the pump cover up to the
stop.
2.Clean the interior, the threads of the
pump cover and the pump housing.
90°
The handle of the pump cover
must be vertical.
Before next wash
To prevent unused detergent from
flowing into the drain during the next
wash, run a suitable draining program
after emptying the pump.
1.Open the water tap.
The pump cover consists of two
components that can be dismantled
for cleaning.
3.Verify that the pump impeller rotates
easily.
2.Insert the plug into the socket.
3.Turn on the device.
4.Pour one liter of water into
compartment II.
38
To Next Page
Loading...
