NLTroubleshooting
Malfunction Cause and Troubleshooting
strong foam
ming.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
▶ Reduce the amount of detergent for the next wash
with the same load.
High centrifuge
rental is not
reached.
Low spin speed is set.
▶ Set a higher spin speed for the next wash.
Imbalance control system compensates for
imbalance by reduced spin speed.
▶ Redistribute the laundry in the drum.
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
▶ Launch the programCentrifuge.
Program centrifuge
run does not start.
Drain pipe or water drain hose is clogged.
▶ Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
trapped.
▶ Make sure that the drain pipe and the water
drain hose are not kinked or trapped.
The imbalance detection system has stopped the spin
cycle due to uneven distribution of the laundry.
▶ Redistribute the laundry in the drum.
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
▶ Launch the programCentrifuge.
Sparkling, hissing
loud.
Water is flushed under pressure into the detergent
drawer.
▶ No error - normal operating noise.
Loud noise during
spin.
The appliance is not leveled correctly.
▶
→
"Adjusting the device", page 16
Device feet are not fixed.
46
To Next Page
Loading...
