NLTroubleshooting
Malfunction Cause and Troubleshooting
▶ Launch the programCentrifuge.Centrifuge result is
not satisfied-
ity. The laundry is too
wet / too damp.
Imbalance control system compensates for
imbalance by reduced spin speed.
▶ Redistribute the laundry in the drum.
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
▶ Launch the programCentrifuge.
Leftover detergent
the damp laundry.
Detergents may contain water-insoluble substances
that settle on the laundry.
▶ Launch the programTo rinse.
Detergent residues
the dry laundry.
Detergents may contain water-insoluble substances
that settle on the laundry.
▶ Brush the laundry after washing and drying.
At the water supply
feed hose is leaking water.
The water supply hose is not correctly / firmly connected.
1.Connect the water supply hose correctly.
→
"Connect the water supply hose", page 15
2.Tighten the coupling properly.
Water is leaking from
the water drain hose.
Water drain hose is damaged.
▶ Replace the damaged water drain hose.
Water drain hose is not connected correctly.
▶ Connect the water drain hose correctly.
→
"Water outlet connection types", page 16
Odor formation has
occurred in the appliance
Pine tree.
Humidity and detergent residue can stimulate
bacterial growth.
▶
→
"Clean the drum", page 35
▶ If you are not using the appliance, leave the door and
detergent drawer open so that the residual water can
dry up.
Fabric softener remains in
the detergent drawer.
Use with fabric softener is not possible for the
selected programme.
▶ Before washing, check whether fabric softener is
possible for the selected program.
→
"Programs", page 25
Water comes out
under the door.
Contamination on the door or seal causes leakage.
▶ Clean the door and the cuff.
48
To Next Page
Loading...
