en Operating the appliance
14
Changing the programme
if you have mistakenly started a wrong
programme.
1. Select Start/Reload.
2. Select another programme.
If required, adjust the presetting
and/or select other functions.
3. Select Start/Reload. The new
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
1. Select Start/Reload.
2. Cool down washing: select Rinse
3. Select Start/Reload.
For programmes at low temperature:
1. Select Start/Reload.
2. Select Spin.
3. Select Start/Reload.
End of the programme
Start/Reload indicate light goes out and
End or - - - - (if - - - - was selected,
without drain) appears on the display
field, buzzer sounds. Set volume of
buzzer ~ Page 19
If - - - - was selected, - - - - is displayed
after the programme ends, touch Start/
Reload button.
Notes
■ The programme continues by
pumping out the water and spinning
the washing (the standard spin
speed can be changed beforehand).
■ If only the water is to be pumped out,
press the Start/Reload button again
before the spinning starts. The
programme is interrupted and the
door lock is released. The washing
can be removed.
After washing
1. Set programm selector to $ Off.
2. Open appliance door and remove
washing.
Notes
– Do not leave any items
of washing in the drum.
In the next wash they may shrink
or discolour something else.
– Remove any foreign objects from
the drum and the rubber seal.
Notes
– Leave detergent drawer and door
open so that residual water can
evaporate.
– Always remove the washing.
3. Turn off the tap.
To Next Page
Loading...
