en Installation and connection
32
Alignment
1. Loosen lock nut in a clockwise
direction with a wrench.
2. Check alignment of the washing
machine with a spirit level and, if
required, correct. Adjust the height
by rotating the foot.
Note: All four feet must be firmly on
the floor.
The washing machine must not
wobble!
3. Tighten the lock nut against the
housing.
Grip the foot and do not adjust the
height.
Notes
– The lock nuts on all four
appliance feet must be screwed
tightly against the housing!
– Loud noise formation, intense
vibrations and “wandering” may
be due to incorrect alignment!
Electrical connection
Electrical safety
:Warning
Danger of death from electric shock!
Danger of death if live parts are
touched.
■ Never pull out the mains plug by
tugging the power cord.
■ Insert/pull out the mains plug with
dry hands only.
■ Never pull out the mains plug during
operation.
■ Connect the washing machine to an
alternating current via a correctly
installed earthed socket only.
■ The mains voltage and voltage
specifications on the washing
machine (appliance rating plate)
must match.
■ Connected load as well as required
fuse are indicated on the appliance
rating plate.
Ensure that:
■ the mains plug and socket match,
■ the cable cross-section is adequate,
■ earthing system has been installed
correctly.
■ A damaged power cord may
be replaced by an electrician only.
A replacement mains cable can be
obtained from customer service.
■ Do not use multiple plugs/couplings
or extension cables.
■ If a residual-current-operated circuit
breaker is used, use only a type
which features this symbol: z.
Only this symbol guarantees
compliance with the currently valid
regulations.
■ The mains plug must be accessible
at all times.
To Next Page
Loading...
