Installation and connection en
33
Before washing for the first
time
The washing machine was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum clean programme the first time
without washing.
Note: The washing machine must have
been installed and connected properly.
See chapter Installing ~ Page 28
1. Insert mains plug.
2. Turn the tap on.
3. Close the washing machine door.
Do not load any washing.
4. Select Drum clean 40°C
programme.
5. Open the detergent drawer.
6. Pour approx. 1 litre of water into
dispenser II.
7. Add standard detergent to
dispenser II according
to manufacturer’s instructions for
light soiling.
Note: To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
standard or mild detergents.
8. Close the detergent drawer.
9. Select Start/Reload.
10.When the programme ends, switch
off the appliance.
Your washing machine is now ready
for use.
Transportation
1. Remove covers and keep in a safe
place.
If required, use a screwdriver.
2. Insert all 4 sleeves.
Clamp mains cable on the holders.
Insert and tighten the bolts.
Before switching on the appliance:
Notes
■ Always remove the transportation
protection devices!
■ To prevent unused detergent from
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the Spin
programme.
To Next Page
Loading...
