en Cleaning and maintenance
22
7. Close service flap. If required,
engage disengaged service flap
beforehand.
Note: To prevent unused detergent
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser II and start the Spin
programme.
Drainage hose on the siphon
blocked
1. Turn the programme selector to $
Off. Pull out the mains plug.
Note: Residual water may run out!
2. Loosen hose clip, carefully remove
drainage hose.
3. Clean drainage hose and siphon
spigot.
4. Re-attach drainage hose and secure
connection point with hose clip.
Filter in the water inlet hose
blocked
First, release water pressure in the
supply hose:
1. Turn off the tap!
2. Select any programme (except Spin
programme).
3. Select Start/Reload. Leave
programme for approx. 40 seconds.
4. Switch off the appliance. Pull out the
mains plug.
5. Clean the filter:
Disconnect the hose from the water
tap.
Clean filter with small brush.
and/or:
Remove hose from the rear of the
appliance.
Take out filter with pliers and clean.
6. Connect the hose and check for
leaks.
To Next Page
Loading...
