To Prepare the Generator for Use
1. Check the list of accessories
Accessories supplied with the instrument are listed below. If anything is
missing or damaged, please contact your nearest SIGLENT Sales Office.
⚫ A Quick Start
⚫ A Certification
⚫ A Guaranty Card
⚫ A CD (EasyWave software, Datasheet and User Manual)
⚫ A power cord designed for use in the destination country
⚫ A USB cable
⚫ A BNC cable
2. Connect the power cord and turn on the generator
The instrument runs a short power-on self-test, which takes several seconds.
The generator powers up in the sine wave function at 1 kHz with an amplitude
of 4 V peak-to-peak (CH1). At power-on, the Output connector is disabled. To
enable the Output connector, press the Output key.
If the generator does not turn on, verify that the power cord is firmly connected
to the power socket on the rear panel (the power-line voltage is automatically
sensed at power-on). Also, make sure that the generator is connected to a
power source that is energized.
Then, verify that the generator is turned on.
Note: If the power-on self-test fails, the generator may stop and display a black
screen. For solutions, please contact the nearest SIGLENT sales office or
return the generator to SIGLENT for service.
To Next Page
Loading...
Need help?
General
