12
Dimension Verification
To verify the dimensions of a sample, the correct metal must be selected and the correct weight must be
entered. To verify the dimensions of a sample, press the button while the device is reading
the sample. Select the shape of the sample using the UP and DOWN buttons. Once the DIMENSION
screen appears, you may move the sample away from the sensor.
• align the right edge of the sample to the vertical dotted line indicated by the
illuminated LED. The left edge of the sample is expected to fall within the green range indicated on
the screen. If the edge falls within the range, then the sample’s density is consistent with the selected
metal. If the left edge falls outside of the green range, then the sample’s density is inconsistent with
the selected metal.
• align the right edge of the sample to the vertical dotted line indicated
by the illuminated LED. Use the UP and DOWN buttons to adjust the indicated width on the screen
to match the width of the sample. While adjusting the width, the illuminated LED may change
to indicate a different vertical dotted line. Re-align the right edge of the sample to the new line.
With both the right edge and width aligned properly, the sample’s left edge should fall somewhere
within the green range. If the edge falls within the range, then the sample’s density is consistent
with the selected metal. If the left edge falls outside of the green range, then the sample’s density is
inconsistent with the selected metal.
The PRO must be actively reading a sample when is pressed to perform dimension
To Next Page
Loading...
