6.4 Programming and Accessing of intermediate
Positions
Two intermediate positions can be set for the Electric Curtain
Track System with low voltage switching. The programming of
the intermediate positions doesn’t have to be carried out in the
programming mode. It can be carried out in operational mode.
Programming with Low Voltage Control:
To do Signal
Step
1
2
3
4
5
6
Check if the DIP switch setting is correct
(Setting according to Chapter 5.8)
Disconnect power supply of the motor for
5 seconds and make sure that the motor
will have permanent power supply
Establish power supply and simultaneously
push programming button 1 or 2 on Motor.
Select the desired chanel by pressing the
select button (only SG 9942)
Push simultaneously programming button
1 and 2, >6 seconds. The motor is now
able to be programmed for 3 minutes
Move to first end position with programming
button 1. Subsequently, push both program-
ming buttons simultaneously for 3 seconds.
The first end position is now saved
Acoustic Signal,
LED lights
Chanel LED on trans-
mitter lights on
Acoustic Signal and
LED blinks after 3 and
6 seconds respectively
Acoustic Signal and
LED blinks 1 x
7 Move to the second end position with pro-
gramming button 2. Subsequently, push
both programming buttons simultaneously
for 3 seconds. The second end position is
now saved
Acoustic Signal and
LED blinks 1 x
To do Signal
Step
1
2
Use button 1 to move the system to the
required scene position 1. When you reach
the required position press button 2 twice
while still holding down button 1
Use button 2 to move the system to the
required scene position 2. When you reach
the required position press button 1 twice
while still holding down button 2. The
intermediate positions are now adjusted.
Acoustic Signal and
LED blinks 1 x
Acoustic Signal and
LED blinks 1 x
To Next Page
Loading...
