Silent Gliss 9021 - Factory Reset Procedure

Usermanual Motors 902x_903x Page 15
Programming with Remote Control:
Recalling the intermidiate positions: The curtain automatically moves to
the programmed positions by briey pressing 2 times the buttons which
are assigned to the intermediate positions.
6.5 Resetting of Motor to Factory Status
To do Signal
Step
1
2
Press button 1 permanently and move the
curtain to the desired intermediate position
1. Arrived at the first intermediate position,
press button STOP simultaneously.
Press button 2 permanently and move the
curtain to the desired intermediate position
2. Arrived at the first intermediate position,
press button STOP simultaneously.
Acoustic Signal and
LED blinks 1 x
Acoustic Signal and
LED blinks 1 x
To do Signal
Step
1
2
Disconnect power supply of the motor for 5
seconds and make sure that the motor will
have permanent power supply when
reconnected. Typically unplug power
lead from motor.
Reconnect to power supply and
simultaneously push programming
button 1 or 2.
Acoustic Signal,
LED blinks
3 Simultaneously press both buttons (1&2)
and hold depressed for > 6 seconds.
After 3 seconds motor will sound and the
light will flash. Do not release the buttons.
Wait until motor sounds and light flashes
for the second time.
Acoustic Signal
and LED blinks
after 3 and 6 seconds
respectively