Silent Gliss 9021 - Page 16

Page 16
Usermanual Motors 902x_903x
6.6 Deleting transmitters 9940 to motors
SG 9021/9023 and SG 9031/9033
Transmitter 9941 (1-Channel)
Transmitter 9942 (5+1-Channel)
To do Signal
Step
1
2
3
Make shure that the motor has permanent
power.
Open the front cover on the device and
press the following buttons simultaneously:
- Programming button P
- STOP button
Keep these two buttons pressed until the
LED goes out briefly.
LED turns off short
1 Make shure that the motor has perma-
nent power.
2a Deleting of a specied channel
Select the channel to be deleted. Then
open the front cover and press the follow-
ing buttons simultaneously:
Programming button P + STOP button
2b Keep all of these buttons pressed until
the LED ashes off short
LED ashes off
short
3a Deleting of all channels
Select all Channel. Open the front cover
and press the following buttons simul-
taneously: Programming button P + UP
button + STOP button + DOWN button
3b Keep all of these buttons pressed until
the LED ash off 3 x
LED ash off 3 x