Silver Peak Hardware Reference Guide
Copyright © September 2018 by Silver Peak Systems, Inc. All rights reserved
58
The server should not be operated in environments that can get wet. Protect the server at all times from
liquid intrusion.
If your server gets wet,
turn off the AC power at the circuit breaker
before attempting to remove the power
cables from the electrical outlet. Then disconnect power to the equipment and to any attached devices.
Avoid obstructing the air vents on the server or pushing objects into the openings. This could lead to fire or
electric shock.
CAUTION To prevent hardware damage or loss of data, observe the following precautions:
Follow installation instructions carefully.
Do not attempt to service the equipment yourself. The server should be serviced by a trained service
technician.
You should operate this equipment from the type of external power source indicated on the electrical ratings
label.
Wait 30 seconds after turning off the equipment before removing a component from the system or
disconnecting a peripheral device from the server.
Always leave at least 4 inches (10.2cm) of physical clearance on all vented sides of the server. This permits
the airflow required for proper ventilation.
Avoid placing equipment too close together such that it is subject to re-circulated (pre-heated) air. Avoid
placing equipment too close to an server or exhaust vent.
Ensure that cables are connected to the server without stress and that nothing rests on the cables.
If the equipment is located in a rack, move it with caution. Ensure that all casters and/or stabilizers are firmly
connected. While moving the equipment, avoid uneven surfaces and sudden stops.
Do not place other equipment, monitors, or other devices on top of the server.
To protect the server from fluctuations in electrical power, use a surge suppressor, line conditioner or
uninterruptible power supply (UPS).
WARNING Installing an incompatible battery on the server board may increase the risk of fire or explosion.
Observe the following precautions:
The battery should only be replaced with a battery that is the same or equivalent as the factory installed
battery.
Do not attempt to open or service the battery. Do not dispose of the battery in a fire or with household waste.
Contact the local waste disposal agency for the location of the nearest battery deposit site.
CAUTION Please observe the following additional precautions for rack-mounted systems:
To Next Page
Loading...
