15
Handling and operation
SAB 160 A1
GB
CY
Handling and operation
In this chapter you receive important information for the handling and operation
of the device.
NOTICE
►
If no setting is made and/or no button pushed within approx. 5 seconds the
device returns to its previous operating mode. Changed settings are saved.
Switching On and Off
♦ Press briefl y the /DIM button to switch the device on. In the display the
notice WELCOME appears.
♦ Briefl y tap the /DIM button. In the display appears MAN DIM H.
♦ Briefl y tap the /DIM button again. In the display appears AUTO DIM.
AUTO DIM: The display illumination will, depending on the lighting conditions,
set automatically (Default setting).
MAN DIM: The display illumination can be set in two stages (H = High and
L = Low) by turning the multi controller.
♦ To switch off hold down the /DIM button longer.
Settings
WARNING
Hearing damage as a result of too high a volume!
If the volume is set too high it can lead to permanent hearing damage.
► Set the volume to moderate levels only.
Volume
♦ Turn the multi controller to set the volume.
Switching mute on and off
♦ Press the button to switch the sound off . “MUTE” blinks in the display.
♦ To switch the sound on again press the button once more. The mute
switching is rescinded when receiving a PTY or TA station.
IB_90468_SAB160A1_LB7.indb 15IB_90468_SAB160A1_LB7.indb 15 28.06.13 13:3828.06.13 13:38
To Next Page
Loading...
