SDBS 2400 B2
■ 12
│
GB
│
IE
│
NI
│
CY
Ironing without steam
NOTE
Always set the temperature control 4 to the lowest level (min) before switching
the appliance on. The symbols on the temperature control 4 correspond to
the following settings:
Symbol Material
Temperature
(approx.)
min –
Synthetics 70–120°C
Silk 70–120°C
Wool 100–160°C
(– max)
Cotton/linen 140–210°C
♦ Insert the plug into a mains power socket.
♦ Set the On/Off switch w to the position "1" to switch the appliance on. The
integrated control lamp in the On/Off switch w and the heat-up indicator
lamp 3 light up, the "MAX" button z flashes.
♦ Turn the temperature control 4 to set the required ironing temperature.
♦ The heat-up indicator lamp 3 lights up during heating. As soon as the heat-
up indicator lamp 3 goes out, the set temperature has been reached and
you can start ironing.
♦ Put the iron down on the stand 7 on the base station q after ironing.
Set the temperature control 4 to "min".
♦ Set the On/Off switch w to the position "0" to switch the appliance off. The
integrated control lamp in the On/Off switch w and the "MAX" button z
go out.
♦ Pull the plug out of the
mains socket.
To Next Page
Loading...
