SDBS 2400 B2
■ 14
│
GB
│
IE
│
NI
│
CY
Vertical steam ironing
♦ Hang the fabric to be ironed on a clothes hanger which is hung against a
heat-resistant surface.
♦ Insert the plug into a mains power socket.
♦ Set the On/Off switch w to the position "1" to switch the appliance on. The
integrated control lamp in the On/Off switch w and the heat-up indicator
lamp 3 light up, the "MAX" button z flashes.
♦ Turn the temperature control 4 to set the required ironing temperature. The
temperature control 4 must be set within the
range to produce steam.
♦ The heat-up indicator lamp 3 lights up during heating. As soon as the set
temperature has been reached, the heat-up indicator lamp 3 goes out.
♦ Adjust the steam power:
– Press the "MAX" button z to create maximum steam.
– Press the "ECO" button tto produce less steam.
♦ As soon as the "MAX" z or "ECO" button t lights up continuously
(depending on the setting), you can start steam ironing.
♦ Hold the steam iron in a vertical position and press the steam button 5.
♦ Touch the fabric lightly with the sole of the iron 6 and steam it to remove
creases.
♦ Release the steam button 5 to stop the appliance producing steam.
♦ Put the iron down on the stand 7 on the base station q after ironing.
Set the temperature control 4 to "min".
♦ Set the On/Off switch w to the position "0" to switch the appliance off. The
integrated control lamp in the On/Off switch w and the steam control lamp
"MAX" z or "ECO" t go out.
♦ Pull the plug out of the mains socket.
Refilling with water
You can refill the appliance with water while it is switched on.
♦ Put the iron down on the stand 7 on the base station q.
♦ Refill the water as described in the section "Filling the water tank".
To Next Page
Loading...
