SDBS 2400 B2
GB
│
IE
│
NI
│
CY
│
15 ■
Cleaning and maintenance
WARNING!
Risk of injury!
► Before cleaning the appliance, disconnect the plug from the mains power
socket!
► Allow the appliance to cool down completely if necessary.
► Never immerse the appliance in water to clean it.
CAUTION
Damage to the appliance!
► To avoid irreparable damage to the appliance, ensure that no moisture can
penetrate the appliance during cleaning.
► Do not use aggressive scouring cleaners or solvents, or a wire brush or
other abrasive objects to clean the surfaces.
Self-cleaning function
♦ Fill the water tank 0 with water if necessary.
♦ If the appliance is switched on, set the temperature control 4 to "MAX" and
wait until the appliance has heated up.
♦ Hold the iron horizontally over a suitable container or sink.
♦ Press the "Self clean" button i for about 5 seconds. The self-cleaning
process starts and the "Self clean" button i flashes. Steam flows from
the steam exit holes in the sole of the iron 6. Any impurities that may be
present are flushed out.
♦ As soon as the self-cleaning process is complete (after about 80 seconds),
the "Self clean" buttoni stops flashing.
Replacing the limescale filter
After pressing the steam button 5 for a total of around 11 hours, it is time to
replace the limescale filter e.
The appliance will notify you when the time comes: As soon as the "Anti calc"
button u flashes, you need to change the limescale filter e.
Proceed as follows:
♦ Set the On/Off switch w to the position "0" to switch the appliance off.
♦ Pull the water tank 0 by the grip 9 out of the base station q.
♦ Pull the limescale filter e upwards out of the limescale filter shaft.
♦ Place the new limescale filter e in the limescale filter shaft and press it
down until it is firmly in place.
To Next Page
Loading...
