SDBS 2400 B2
GB
│
IE
│
NI
│
CY
│
13 ■
Steam ironing
♦ Fill the water tank 0 with water if necessary.
♦ Insert the plug into a mains power socket.
♦ Set the On/Off switch w to the position "1" to switch the appliance on. The
integrated control lamp in the On/Off switch w and the heat-up indicator
lamp 3 light up, the "MAX" button z flashes.
♦ Turn the temperature control 4 to set the required ironing temperature. The
temperature control 4 must be set within the
range to produce steam.
♦ The heat-up indicator lamp 3 lights up during heating. As soon as the set
temperature has been reached, the heat-up indicator lamp 3 goes out.
♦ Adjust the steam power:
– Press the "MAX" button z to create maximum steam.
– Press the "ECO" button t to make the appliance produce less steam.
♦ As soon as the "MAX" z or "ECO" button t lights up continuously
(depending on the setting), you can start steam ironing.
♦ While you are ironing, you can now press and hold the steam button 5 to
continuously spray steam onto the items being ironed from the sole of the
iron 6. Release the steam button5 to stop producing steam.
NOTE
When you press the steam button 5, it can take a few seconds until steam
comes out of the sole of the iron 6.
♦ Put the iron down on the stand 7 on the base station q after ironing.
Set the temperature control 4 to "min".
♦ Set the On/Off switch w to the position "0" to switch the appliance off. The
integrated control lamp in the On/Off switch w and the steam control lamp
"MAX" z or "ECO" t go out.
♦ Pull the plug out of the mains socket.
To Next Page
Loading...
