Silvercrest SEMM 1470 A1

Questions and Answers:

L
Lori AdamsSep 6, 2025
What to do if espresso drips over the edges of the sieve holder of Silvercrest SEMM 1470 A1 Coffee Maker?
- R
  Ronald SmithSep 7, 2025
  If the espresso drips over the edges of the sieve holder instead of from the openings, it could be due to a few reasons. First, ensure the sieve holder is correctly inserted. If it is, check if the sieve holder openings are blocked and clean the sieve holder if necessary. Also, make sure to clean any espresso powder residues from the edges of the sieve holder.
A
Andrew FuentesAug 22, 2025
How to fix milk frothing problem on Silvercrest Coffee Maker?
- M
  Megan TaylorAug 22, 2025
  If the milk is not being frothed by your Silvercrest Coffee Maker, check the "Milk quantity" knob. If it's pointing to the " " symbol or beyond, it's in cleaning mode; turn it to the left until it points to the " " symbol to produce milk froth. Also, the milk tank lid and/or the milk nozzle might be blocked. Clean them as described in the section "Cleaning the milk nozzle and milk tank".
N
nrandallSep 4, 2025
What to do if espresso drips over the edges of the sieve holder on my Silvercrest SEMM 1470 A1 Coffee Maker?
- V
  Victoria TaylorSep 4, 2025
  If the espresso drips over the edges of the sieve holder instead of flowing from the openings in your Silvercrest Coffee Maker, ensure that the sieve holder is correctly inserted. Also, the sieve holder openings may be blocked and require cleaning. Another possibility is espresso powder residues on the edges of the sieve holder, so clean those residues off.
G
Garrett TurnerSep 2, 2025
Why is no espresso flowing out of my Silvercrest SEMM 1470 A1?
- K
  Karen TuckerSep 2, 2025
  If the espresso no longer flows out of your Silvercrest Coffee Maker, it could be due to a few reasons. First, the espresso powder might be too moist or compressed too tightly; try re-preparing the espresso, ensuring it's not compressed as much, or replace it entirely. Secondly, check if the water tank is empty and fill it with water if needed. Lastly, the holes of the sieve holder might be blocked, so give the sieve holder a good cleaning.
P
Phillip KingSep 1, 2025
Why is my Silvercrest SEMM 1470 A1 pump so noisy?
- U
  umartinezSep 1, 2025
  If the pump of your Silvercrest Coffee Maker is unusually noisy, it might be because the water tank is empty. Fill the water tank with water.
S
Sandra PrinceAug 30, 2025
How to fix dark crema from Silvercrest Coffee Maker?
- T
  Timothy McleanAug 30, 2025
  If the crema is too dark and the espresso runs out of the sieve carrier slowly when using your Silvercrest Coffee Maker, it could be because you're using too much espresso powder. Try using less espresso powder. Also, the powder might be too finely ground. Use only espresso powder that is specially produced for making espresso.
A
Ann HarrisonAug 29, 2025
How to fix espresso not flowing in Silvercrest Coffee Maker?
- J
  jacquelineleeAug 29, 2025
  If your espresso isn't flowing, here's what you can check: First, the espresso powder could be too moist or compressed too tightly. Try making it again without compressing it as much, or use fresh powder. Next, make sure the water tank is filled with water. Also, the holes in the sieve holder might be blocked, so clean the sieve holder.
A
adamsbrookeAug 27, 2025
Why is no espresso coming out of my Silvercrest Coffee Maker?
- B
  Bryan GrahamAug 27, 2025
  There could be a few reasons why espresso isn't flowing. It might be due to overly moist or compressed espresso powder; try re-preparing with less compression or replace the powder. Another cause could be an empty water tank, so ensure it's filled. Lastly, check if the sieve holder openings are blocked and clean them if needed.
M
Mr. Eric BerryAug 27, 2025
What to do if espresso no longer flows out of my Silvercrest Coffee Maker?
- A
  Aaron MillerAug 27, 2025
  If the espresso is not flowing, several factors could be at play. First, the espresso powder might be too moist or compressed too firmly; in this case, try re-preparing the espresso, ensuring not to compress it as tightly, or replace the coffee powder entirely. Secondly, check if the water tank is empty and refill it with water if necessary. Finally, the sieve holder openings might be blocked; clean the sieve holder to resolve this issue.
E
ehollowayAug 25, 2025
How to fix too light crema in Silvercrest SEMM 1470 A1 Coffee Maker?
- B
  Brooke ToddAug 26, 2025
  If the crema is too light and the espresso runs out of the sieve holder quickly, the coffee powder may be too fine or coarsely ground. Try using coarse coffee powder or coffee powder that is specially produced for making espresso.