Silvercrest SHF 1800 A1 - Kebab Skewers

42
GB
10.4 Kebab skewers
Required parts
Rotary spit10
2 support discs16
8 kebab skewers15
Handle11
Tray / grease drip tray17
Procedure
1. Slide the grease drip tray17 at the bot-
tom on to the floor of the interior.
2. Attach the two support discs16 at the
ends of the rotary spit10. The locking
screws7 must be aligned exactly to the
markings9.
3. Cut the ingredients into pieces of maxi-
mum 3 cm in diameter.
4. Place the ingredients on the kebab
skewers15. Leave the length of the
handle at the top free and at the bottom
at least 2.5 cm.
5. Insert the kebab skewers15 into the
support discs16 as shown:
- the lower end into a round hole in the
outer ring,
- the upper end through a notch in the
edge and a round hole in the inner
ring.
6. Attach all 8 kebab skewers15 in this
way.
NOTE: you can also only use 4 kebab skew-
ers15. In that case use every second notch
so that the kebab skewers are evenly distrib-
uted.
7. When all the kebab skewers15 are at-
tached, use the handle11 to insert the
kebab skewer wheel into the device1
(see “Inserting the rotating basket/rota-
ry spit” on page 40).
__332724_1907_Heissluftfritteuse 9 in1_B8.book Seite 42 Mittwoch, 11. Dezember 2019 11:19 11