Silvercrest SHFD 1400 C1 - Interrupting and Resuming Cooking; Completing the Cooking Cycle

81
GB
8.6 Interrupting the
cooking process
You can interrupt the cooking process at any
time, e.g. to check the degree of browning.
1. Take the pan10 by the handle9 and
remove it from the housing1. When the
pan10 is taken out, the device auto-
matically switches itself off.
- The button symbol 20 flashes.
- The heating symbol 24 is no
longer displayed.
- The program symbol flashes.
- The temperature and cooking time are
displayed alternately.
- The fan stops until the pan10 is rein-
serted.
2. Reinsert the pan10 into the device. The
device switches on again automatically
until the cooking time has expired.
or
1. Briefly press the Start/Stop button  20
to interrupt the cooking process.
- A signal sounds.
- The button symbol 20 flashes.
- The heating symbol 24 is no
longer displayed.
- The program symbol flashes.
- The fan symbol 25 flashes.
- The temperature and cooking time are
displayed alternately.
- The fan continues to run for approx.
1minute.
2.
Press the Start/Stop button  20 again
to continue the cooking process.
8.7 End of the cooking
process
• An audio signal sounds when the pro-
gram has finished. The fan continues to
run for approx. 1 minute.
• You need a heat-resistant surface for the
pan10 and the frying basket5 and a
plate or bowl (pre-heated if necessary).
• To disconnect the device from the mains
pull the mains plug11 after use.
1. Use the handle9 to pull the pan10 out
of the housing1. Place the pan10 on
the heat-resistant surface.
2. Figure A: slide the safety catch7 in
the direction of the arrow.
3. Press the button for unlocking the frying
basket8 and lift the frying basket5 up-
wards out of the pan10.
4. Place the frying basket5 on the heat-re-
sistant surface. Place the food on the
prepared plate / in the prepared bowl.
5. Allow the device and accessories to
cool down before cleaning them.
NOTE: if, for example, the degree of
browning does not yet meet your require-
ments, you can adapt the cooking process
manually (see “Manual settings” on
page 80). Slide the pan10 with the filled
frying basket5 back into the housing1 and
restart the cooking process. Check the level
of browning after a few minutes. Simply pull
the pan10 by the handle9 out of the hous-
ing1 and then replace it again.
__438124_2304_B5.book Seite 81 Mittwoch, 21. Juni 2023 9:00 09