Silvercrest SKM 600 A1 - Filling Quantities and Operation; After Use Procedures

■ 18
│
GB
│
IE SKM 600 A1
– Push the attachment 0 q w firmly onto the
drive shaft 7 so that the spring compresses,
and rotate the attachment 0 q w anti-
clockwise a little way (towards
).
– Let go of the attachment 0 q w. It is
now sitting firmly on the drive shaft 7.
5) Put the ingredients into the mixing bowl 6,
observing the following table with the recom-
mended filling quantities:
Filling quantities for... min. max.
Yeast dough N/A
500 g
flour
Cake mixture N/A
400 g
flour
Heavy dough
(e.g. shortcrust pastry)
N/A
400 g
flour
Cream 200 ml 1000 ml
Egg white
(weight class M)
2 12
Adapt the remaining ingredients in the recipe to
the respective maximum quantity.
CAUTION! PROPERTY DAMAGE!
► Do not exceed the specified maximum filling
quantities!
Otherwise the appliance will be overloaded.
► If the appliance is labouring: Switch off the
appliance, remove half of the dough and
knead each half separately.
NOTE
► Please note that during the kneading or stirring
process, the mixture in the mixing bowl 6
increases in volume or is pressed upward
slightly as a result of the movement. You
should therefore never fill the mixing bowl 6
right up to the top!
6) Press the release button 2
and press the
swivel arm 1 with the mounted attachment 0
q w downwards into the working position.
NOTE
► If you wish, you can fit the filling accessory 8
onto the lid 9:
– Press the filling accessory 8 into the
cut-out on the lid 9.
Now you can add ingredients even during
operation.
7) Push the lid 9 onto the mixing bowl 6.
8) Turn the rotary switch 3 to the required level
(see the section “Speed settings”).
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch 3
(Position “OFF”).
2) Remove the lid 9 from the mixing bowl 6.
3) Push the release button 2
and move the
swivel arm 1 to the highest position.
4) Remove the attachment 0 q w from the drive
shaft 7 by pushing the attachment 0 q w
against the drive shaft 7 and turning clock-
wise (direction
) at the same time. Then you
can remove the attachment 0 q w.
5) Remove the mixing bowl 6 by turning it anti-
clockwise and then pulling it upwards.
6) Clean the appliance (see section “Cleaning
and care”).