Silvercrest SKMP 1300 D3 - Jug and Lid Removal

40
GB
Seal6 for blade assembly7:
To clean, remove the seal6 of the blade as-
sembly7.
CAUTION:
~ When you put the blade assembly7
back into the blender jug5, the seal6
of the blade assembly7 must fit correct-
ly, otherwise the contents may leak.
In order to insert the blade assembly7, pro-
ceed as follows:
1. Turn the blender jug5 upside down.
2. Place the blade assembly7 carefully
into the blender jug5.
3. Turn it anticlockwise at the two han-
dles25 until it stops.
Note that the lower ridges26 at the
base of the blade assembly7 must en-
gage under the upper ridges27 in the
blender jug5. Check that it is secure.
25
25
26
27
__349710_711_Kuechenmaschine_B8.book Seite 40 Mittwoch, 20. Mai 2020 2:06 14