US-EN 11
Getting ready
Two-step presser foot lifter
When sewing thick fabrics, the passage
of fabrics under the presser foot can be
improved by raising the two-step presser
foot lifter (18) further (arrow).
Attaching the presser foot holder
Important:
Turn the power switch (20) to off ("O")
when carrying out all the operations!
1. Install the presser foot holder
Raise the presser bar (A) by lifting the
two-step presser foot lifter (18). Attach
the presser foot holder (B) as illustrated.
2. Inserting the presser foot
Lower the presser foot bar (A) until the
groove (C) is directly above the pin (D).
Lower the presser foot bar (A) as far
as it will go. The presser foot (a) will
engage automatically.
3. Removing the presser foot
Raise the presser foot.
Press the lever (E) gently towards the
front and the presser foot disengages.
4. Inserting the edge/ quilt guide (p)
As shown in the illustration carefully
insert the edge/ quilt guide (p) e.g. For
hems, pleats, etc.
C
D
E
a
E
p
B
A
21
3
4
To Next Page
Loading...
Need help?
General
